what is the best free digital signage software

World is now changing and using new technologies to get high performance as well as cost effective solution. As in the past, SAMSUNG, LG, AUO, BOE, and other well-known LCD panel suppliers only provided fully finished panels, resulting in high costs. With the advancement of the LCD industry, the cost of a whole machine is now lower than the cost of an LCD panel. As a result, Clients are looking for another cost-effective solution to assure a reasonable profit. Then, in order to reduce the material cost of the External Frame, the Open Cell solution is developed, which helps up the expansion of small-scale companies in the LCD industry. So, what is open cell solution and how it’s going to make a cost effective solution? An Open Cell is just a part of LCD panel without backlight. As we all know that getting the fully finished LCD panel (Traditional LCD module product) from SAMSUNG, LG, AUO, BOE, and other well-known suppliers were expensive. But, if we use Open cell solution to assemble all parts by ourselves to achieve the complete LCD module panel that would be very cost effective. In another approach, the Open Cell solution will not only reduce the cost of the LCD screen, but will also make the entire machine thinner than before. Certainly, a solution with a cheaper cost and a more fashionable appearance is currently very popular. The Open Cell Solution products will be the dominant trend in the LCD sector in the near future.

With the popularization of the construction of national smart cities and safe cities, LCD splicing screens, as the best terminal display equipment, are favored by various industries and are perfectly integrated into our lives; as we all know, the LCD splicing industry is a sunrise industry with broad development. The prospects and entry barriers are extremely low. Therefore, the LCD splicing market has attracted an influx of many manufacturers, and the actual products of manufacturers are uneven. The viewing angle of the LCD splicing screen can reach 178 degrees, while the ordinary LCD can only see the 178-degree blank space. This is a very important criterion for distinguishing LCD splicing screens and LCD monitors. There is also the difference between the input signals of the two. The splicing screen is mainly the input video signal. In order to meet the interface requirements of different front-end devices, the splicing screen interface will be much richer than the display, including BNC, VGA, RGB, HDMI, DVI, S A variety of interfaces such as terminals meet the input requirements of different signals, while the monitor mainly inputs VGA signals, and the interfaces are mainly VGA, S-terminal, etc., which cannot meet the signal input requirements of various monitoring equipment. What is the difference between an LCD splicing screen and an LCD monitor, be sure to read it clearly when buying The driving scheme of LCD splicing screen is different, that is, the display motherboard scheme is different. Since the LCD display usually takes no more

With the wide application of LCD in vehicle products, instruments and other electronic products, there will always be flashing in the process of use, which will affect the use of customers. What we should do at this time? Now we would like to share with you the causes and solutions of LCD screen flashing： The frequency of the LCD screen itself is too high, resulting in the flash screen. However, in real life, it is rare for the device to flash due to high frequency. According to the industry technical personnel, people’s naked eyes have no sense of flicker for images over 60Hz, while the design standard of general LCD screens is basically within this data range, so under normal circumstances, the frequency will not be too high, but at the same time, the screen itself will not be excluded from failure. After testing by relevant instruments, it is really the fault of the screen itself. In addition to replacing the new monochrome LCD screen, it is to design the software related to the equipment. LCD flash screen solution: the best way is to increase the OSC frequency of IC to see the flash of LCD screen. Of course, if the LCD has separate row and column drivers, it can also be adjusted by setting the driver chip.   The frequency of LCD is close to that of light source. This is very common. Because the frequency of different light source is different, in some specific cases, when the frequency